Silver diammine fluoride (SDF) is known as a noninvasive, cost-effective, safe, and simple method of dental caries treatment. However, staining and discoloration seem inseparable with SDF and continue as a cosmetic concern. Research is ongoing to overcome these issues, for example, by using glutathione (G) or potassium iodide among others. Therefore, the study aimed to investigate the effects of incorporating different concentrations of capping agents on SDF chemistry and SDF-mediated tooth staining at different time points. Tannic acid (TA), gallic acid (GA), carboxymethyl chitosan (CM), and G at different concentrations (5, 10, and 15% w/v) were incorporated in 30% SDF. FTIR and UV-Vis spectroscopies of the prepared solutions was performed to evaluate chemical changes. Time-dependent color changes (ΔE) in bovine dentine specimens (6 × 6 × 1 ± 0.25 mm3) were measured spectrophotometrically at application/washup, 1 and 3 h, after 1, 2, 4, 7, and 14 days. Results showed suppression of FTIR peaks at 3,358 cm-1 and 1,215 cm-1 in capping agent-modified SDF indicative of a successful capping effect of the silver ions, which was corroborated by UV-Vis blueshift of ∼∆32 nm. The capping effect on SDF increased proportionally with the concentrations of TA, GA, CM, and G used. A more pronounced tooth staining reduction however was shown more in TA- and G- rather than in GA- and CM-modified SDF. At day 14, SDF showed the highest mean ΔE(50.14 ± 2.14), while 15% TA showed the lowest ΔE(30.14 ± 0.81). In conclusion, capping agent incorporation significantly reduced SDF-mediated tooth staining. This reduction in staining is more dependent on the respective capping agent functional groups than concentrations per se. The potential of capping agents to minimize tooth staining of SDF was TA>G>CM>GA.
INTRODUCTION: In an attempt to manage noncavitated carious lesions noninvasively through remineralization, a range of novel fluoride varnishes with additional remineralizing agents have been made available for clinical application.
AIM AND OBJECTIVES: The aim of this study was to compare and evaluate the remineralization potential of three commercially available varnishes on artificial enamel lesions.
MATERIALS AND METHODS: This in vitro study involves eighty intact enamel specimens prepared from premolars extracted for orthodontic purposes. After specimen preparation, the eighty samples were divided randomly into two groups (n = 40) for measurement of baseline surface Vickers microhardness and baseline calcium/phosphorus ratio (% weight) through EDAX testing. Thereafter, the specimens were subjected to demineralization for 96 h to induce initial enamel lesions and the measurements were repeated. Following demineralization, each of the two groups was divided randomly into four subgroups (n = 10) from which one was used as the control group and the others three were allotted to each of the three test varnishes. After varnish application, all the specimens were subjected to a pH cycling regimen that included alternative demineralization (3 h) and remineralization (21 h) daily, for 5 consecutive days. The Vickers microhardness and EDAX measurements were then repeated.
RESULTS: One-way ANOVA and post hoc Tukey's tests were conducted for multiple group comparison. All the three commercially available varnishes were capable of remineralizing initial enamel lesions that were induced artificially. No difference was noted in the remineralizing efficacy of the varnishes despite their different compositions. MI Varnish™ (casein phosphopeptide-amorphous calcium phosphate fluoride varnish) showed slightly better recovery in surface microhardness as compared to the other two varnishes.
CONCLUSION: All the varnishes used in this in vitro study are capable of reversing early enamel lesions.