This study aimed to determine the best parameters (types of buffer, hydrolysis time and enzyme concentration) used to produce good quality of liquid protein hydrolysate from Yellowstripe scad in terms of high yield, protein content and concentration. The choice of buffer (sodium or potassium buffer), hydrolysis time (1 h, 2 h, 3 h or 4 h) and enzymes concentrations (0.5%, 1.0%, 1.5% and 2.0%) were investigated. The results obtained from two way ANOVA showed that these parameters had significant difference (p
Epoxy shape memory foam (ESM) was produced by an advanced aqueous method. Mixture of epoxy, sodium bicarbonate,
hardener and ammonium chloride was premixed and emulsified in distilled water by using high speed stirring (at 1200
rpm). The content of sodium bicarbonate used was 5, 10, 15 and 20 phr. Besides that, ammonium chloride was used
(based on stoichiometrical content) to also function as acidifying agent in initiating the decomposition process of sodium
bicarbonate at lower foaming temperature. The foam morphology was observed using SEM. It was found that higher
sodium bicarbonate produced more porosity, more cell size, thinner cell wall and more cell interconnection. Epoxy shape
memory foam with 10 phr of sodium bicarbonate exhibited good shape memory property and better compression set.
Shape memory behaviour was measured by the recovered time of the transformed sample to its original shape.
The effect of sodium as a co-dopant on the thermoluminescence (TL) properties of copper-doped zinc lithium borate (ZLB: Cu) subjected to Co-60 gamma radiation is reported in this study. TL intensity is enhanced with the introduction of sodium in ZLB: Cu. The obtained glow curve is simple with a single peak. The annealing procedure and the best heating rate for the proposed thermoluminescent dosimeter (TLD) are established, and the phosphor is reusable. The TL response within the dose range of 0.5-1000Gy is investigated. The results show that the thermal fading behaviour is improved significantly.
A new lead(II) electrode has been constructed with poly(hydroxamic acid) (PHXA) as the active material and silicone rubber as the supporting material. The electrode gave near Nerstian response over the concentration range 4 x 10(-5)-1 x 10(-2)M lead(II). The detection limit of the electrode is approximately 4 x 10(-6)M and the electrode works well in the pH range 4.5-6.0. The response time was 50-120 sec over the whole concentration range and the electrode has a working life of at least 4 weeks. Iron(III) severely poisoned the electrode membrane. Nickel(II) and mercury(II) gave very strong interference compared to copper(II), silver(I), cobalt(II), sodium(I), potassium(I), zinc(II) and cadmium(II) which gave some or little interference. Values determined with atomic absorption (AAS) and a commercial lead(II) electrode were in good agreement with those measured with the lead(II) electrode reported here.