Agro-waste from the bark of Metroxylon sagu (sago) was studied as a low cost and effective oil sorbent in dry and aqueous environments. Sorption study was conducted using untreated sago bark (SB) and esterified sago bark (ESB) in used engine oil. Characterization study showed that esterification has successfully improved the hydrophobicity, buoyancy, surface roughness and oil sorption capacity of ESB. Sorption study revealed that water uptake of SB is higher (30 min static: 2.46 g/g, dynamic: 2.67 g/g) compared with ESB (30 min static: 0.18 g/g, dynamic: 0.14 g/g). ESB, however, showed higher oil sorption capacity in aqueous environment (30 min static: 2.30 g/g, dynamic: 2.14) compared with SB (30 min static: 0 g/g, dynamic: 0 g/g). ESB has shown great poTENTial as effective oil sorbent in aqueous environment due to its high oil sorption capacity, low water uptake and high buoyancy.
Biodiesel from palm oil mill sludge (POMS) was prepared in the presence of novel silica-based heterogeneous catalysts derived from Imperata cylindrica sp. Imperatacid and Imperatabase are two types of heterogeneous catalysts derived from Imperata cylindrica sp and characterized using scanning electron microscopy, Energy Dispersive X-ray, Brunauer-Emmett-Teller surface area and pore size measurement. Imperatacid has particle size of 43.1-83.9 µm while Imperatabase in the range of 89-193 µm. Imperatacid was conveniently applied in esterification step to afford > 90 wt% oil in 1:3 (oil/methanol) and 10 wt% catalyst, followed by transesterification with 1 wt% Imperatabase and 1:1 (oil/methanol) for 1 h at 65°C to afford 80% biodiesel with higher percentage of methyl palmitate (48.97%) and methyl oleate (34.14%) compare to conventional homogeneous catalyst. Reusability of the catalyst up to three times afforded biodiesel ranging from 78-80% w/w. The biodiesel was demonstrated onto alternative diesel engine (Megatech(®)-Mark III) and showed proportional increased of torque (ɽ) to biodiesel loading.
This study reports the concentrations of trace metals in core sediments profile from the coastal and four rivers estuary in the Kuching Division of Sarawak, Malaysia, and the controlling mechanisms influencing their availability in sediments of the studied area. The bonding of trace metals with non-mobile fractions was confirmed with the sequential extraction. Inductively coupled plasma-optical emission spectroscopy (ICP-OES) was used to measure the concentrations of the trace metals. Granulometric analyses were performed using normalized sieve apertures to determine the textural characteristics of the sediments. Enrichment factor was used to evaluate the level of metal enrichment. Heavy metals concentrations in sediment samples varied in the range: Pb (8.9-188.9 mg/kg d.w.), Zn (19.4-431.8 mg/kg d.w.), Cd (0.014-0.061 mg/kg d.w.), Ni (6.6-33.4 mg/kg d.w.), Mn (2.4-16.8 mg/kg d.w.), Cu (9.4-133.3 mg/kg d.w.), Ba (1.3-9.9 mg/kg d.w.), As (0.4-7.9 mg/kg d.w.), Co (0.9-5.1 mg/kg d.w.), Cr (1.4-7.8 mg/kg d.w.), Mg (68.8-499.3 mg/kg d.w.), Ca (11.3-64.9 mg/kg d.w.), Al (24.7-141.7 mg/kg d.w.), Na (8.8-29.4 mg/kg d.w.), and Fe (12,011-35,124.6 mg/kg d.w.). The estimated results of the enrichment factor suggested enrichments of Pb, Zn, and Cu in all the core sediment samples and depths at all sites. The other trace metals showed no enrichments in almost all the sampled stations. Continuous accumulation of Pb, Zn, and Cu metals over a period can be detrimental to living organisms and the ecology. The results obtained from the statistical analyses suggested that the deposition of trace metals in the studied sites is due to anthropogenic inputs from the adjacent land-based sources.
Sago bark (SB) and empty fruit bunch (EFB) are available abundantly as agricultural waste in Sarawak. This study was conducted to investigate the physicochemical characteristics of SB and EFB as composting materials and used as a plant growth medium. The SB and EFB composts were prepared in a separate container by mixing chicken manure as compost accelerator and wood chips as a bulking agent in dry weight equivalent ratio (1:1:1). The maturity and stability of compost in 60-day composting periods were evaluated via physicochemical characterization of the composts in terms of pH, elemental content, total ash content, moisture content and nutrient analyses. The effect of the compost usage as growth medium was assessed towards water spinach and green mustard via seed germination and pot study. After 2 months, the colour of both composts was dark brown with an earthy smell. The acidic pH of the initial composting stage has changed into alkaline pH after 60 days of composting. Total NPK present in the SB and EFB composts were 0.96% and 1.21%, respectively. The germination index (GI) for the studied vegetables was above 100%, while the pot study showed that vegetables in compost media has higher growth compared to the control, after 14 days. SB and EFB are renewable waste which can be used as an excellent compost and able to improve the quality of the soil.
This research provides a comprehensive analysis of groundwater pollution in the Lower Anayari Catchment (LAC) through δ2H and δ18O isotopic analysis, along with positive matrix factorization (PMF) and PCS-MLR receptor models. Forty groundwater samples were collected from hand-dug wells and equipped boreholes across the LAC. Flame photometry for Na+ and K+, complexometric titration for Ca2+, ion chromatography for Cl-, F-, NO3-, SO42-, and PO43-, and atomic absorption spectrometry for Mg2+, Fe, Pb, Cd, As, and Ni were analytical techniques/instruments employed. In regard to cations, Na+ has the highest average concentration of 63.0 mg/L, while Mg2+ has the lowest at 2.58 mg/L. Concerning the anions and nutrients, Cl- has the highest mean concentration of 18.7 mg/L, and Fl- has the lowest at 0.50 mg/L. Metalloids were detected in trace amount with Fe displaying the highest mean concentration of 0.077 mg/L whereas Cd and As recorded lowest (0.001 mg/L). The average values for groundwater δ18O and δ2H were - 3.64‰ and - 20.7‰, respectively; the average values for rainwater isotopic composition were - 3.41‰ for δ18O and - 17.4‰ for δ2H. It is believed that natural geological features, particularly biotite granitoid and volcanic flow/subvolcanic rocks from the Birimian Supergroup, significantly influence groundwater mineralisation. Additionally, the impact of anthropogenic activities on water quality, with urban development and agricultural practices, may be attributed to increasing levels of certain contaminants such as Fe, Ni, NO3-, and PO43-. This research contributes to the broader field of hydrological study and provides practical implications for managing and conserving water resources in similar contexts. The innovative combination of isotopic and statistical analyses sets a new standard for future studies in groundwater quality assessment, emphasising the need for comprehensive approaches that consider both geological characteristics and human impacts for sustainable water resource management.
This study investigated the impact of soil type, pH, and geographical locations on the accumulation of arsenic (As), lead (Pb), and cadmium (Cd) in rice grains cultivated in Ghana. One hundred rice farms for the sampling of rice grains and soil were selected from two regions in Ghana-Volta and Oti. The concentrations of As, Pb, and Cd were analyzed using ICP-OES. Speciation modeling and multivariate statistics were employed to ascertain the relations among measured parameters. The results showed significant variations in soil-As, Pb, and Cd levels across different soil types and pH ranges, with the highest soil-As and Cd found in alkaline vertisols. For soil-As and Cd, the vertisols with a pH more than 7.0 exhibited the highest mean concentration of As (2.51 ± 0.932 mgkg-1) and Cd (1.00 ± 0.244 mgkg-1) whereas for soil-Pb, the luvisols of soil types with a pH less than 6.0 exhibited the highest mean concentration of Pb (4.91 ± 1.540 mgkg-1). Grain As, Pb, and Cd also varied across soil types and pH levels. In regards to grain-As, the vertisols soil type, with a pH less than 6.0, shows the highest mean concentration of grain As, at 0.238 ± 0.107 mgkg-1. Furthermore, vertisols soil types with a pH level less than 6.0 showed the highest mean concentration of grain Cd, averaging at 0.231 ± 0.068 mgkg-1 while luvisols, with a pH less than 6.0, exhibited the highest mean concentration of grain Pb at 0.713 ± 0.099 mgkg-1. Speciation modeling indicated increased bioavailability of grains Cd2+ and Pb2+ ions in acidic conditions. A significant interaction was found between soil-Cd and pH, affecting grain-As uptake. The average concentrations of soil As, Pb, and Cd aligned with international standards. Generally, the carcinogenic metals detected in grain samples collected from the Volta region are higher than that of the Oti region but the differences are insignificant, and this may be attributed to geographical differences and anthropogenic activities. About 51% of the study area showed a hazard risk associated with grain metal levels, although, no carcinogenic risks were recognized. This study highlights the complex soil-plant interactions governing metal bioaccumulation and emphasizes the need for tailored strategies to minimize metal transfer into grains.