This clinical report demonstrates how a two-implant mandibular implant-supported overdenture is planned and executed. The following steps feature the dual scan technique as part of implant planning and a radiographic-turned-surgical stent to guide a freehand, two-stage surgical placement of two implant fixtures on the bilateral canine positions of the mandibular arch.
This clinical case report demonstrates the use of the Dahl Concept in the management of the repeated dislodgement of a posterior full coverage crown associated with a reduced restorative space. The described technique harnesses the addition of resin composite and a temporarily cemented provisional full coverage crown to create sufficient restorative space for the cementation of a definitive posterior full coverage crown restoration at the six-month review.
This study investigated the effects of environmental pH on the flexural properties of ion-releasing restorative materials (IRMs), including giomer (Beautifil-Bulk Restorative - BB), alkasite (Cention N - CN), bioactive composite (Activa - AB) and resin-modified glass ionomer (Riva Light Cure -RV) restoratives. A bio-inert resin-based composite (Filtek Bulk-fill Posterior - FB) served as the control. Stainless steel molds were used to fabricate 40 beam-shaped specimens (12mm × 2mm × 2mm) for each material. The specimens were finished, measured, and randomly distributed into four groups (n=10) and immersed in aqueous solutions of pH 3.0, pH 5.0, pH 6.8, and pH 10.0 at 37°C for 28 days. Specimens were then subjected to a uniaxial three-point bending flexural test with a load cell of 5 KN and a fixed deformation rate of 0.5 mm/min until fracture occurred. Flexural modulus and strength were statistically analyzed using analysis of variance/Dunnet T3's test (p=0.05). Mean flexural modulus varied from (2.40±0.41 to 9.65±1.21 GPa), while mean flexural strength ranged from (21.56±2.78 to 163.86±13.13 MPa). Significant differences in flexural properties were observed among the various pH values and materials. All materials immersed in artificial saliva (pH 6.8) presented the highest flexural properties, except AB. The flexural strength of AB was significantly better when exposed to acidic environments. FB had better flexural properties than IRMs after exposure to a range of environmental pH values.