Desensitization of teeth after cavity preparation has been recommended in an attempt to avoid post-operative sensitivity. However, there is concern regarding application effect of desensitizing agent on shear bond strength of the adhesive system used. The purpose of our study was to compare the shear bond strength of adhesive system in two different dentin surface treatments, with and without desensitizing agent. Sixteen extracted human premolars were sectioned off at the coronal portion to expose the flat dentin surfaces. The surfaces were finished using 600 Grit Wet Silicon Carbide abrasive papers. The premolars were randomly assigned to two groups: control and treated with MS Coat desensitizing agent. The desensitizer was applied according to manufacturer’s instruction. Resin composite was bonded to each dentin surface using Prime & Bond ® adhesive system. The composite resin was debonded by shear stress. Mann-Whitney Test was used in statistical analysis. Our result showed that application of MS Coat desensitizing agent on dentin surface had significantly reduced the shear bond strength of the adhesive system used (z = - 0.14, p < 0.05). Thus, we conclude that shear bond strength of Prime & Bond ® NT (Dentsply, USA) adhesive system will be reduced if dentin surface is treated with MS Coat (Sun Medical, Japan) desensitizing agent.
Since the establishment of implant in dentistry, the use of removable partial denture in replacing missing teeth apparently becomes less popular. The situation is made worse by the renowned limitations of removable partial denture. One of the obvious limitations of removable partial denture, especially in replacing missing anterior teeth is the unsightly view of metal used for retentive clasp. This case report describes the use of spring loaded plunger attachments as an alternative way to achieve retention and at the same time improving the aesthetic of the prosthesis.