INTRODUCTION: SCF has been reported to improve calcium absorption. We investigated the long-term effect of SCF and calcium on bone indices of healthy preadolescent children aged 9-11 years old.
METHODS: In a double-blind, randomised, parallel arm study, 243 participants were randomised into four groups: placebo, 12-g SCF, 600-mg calcium lactate gluconate (Ca) and 12-g SCF + 600-mg calcium lactate gluconate (SCF + Ca). Total body bone mineral content (TBBMC) and total body bone mineral density (TBBMD) were measured using dual-energy X-ray absorptiometry at baseline, 6 and 12 months.
RESULTS: At 6 months, SCF + Ca had a significant increase in TBBMC from baseline (27.14 ± 6.10 g, p = 0.001). At 12 months, there was a significant increase in TBBMC from baseline in the SCF + Ca (40.28 ± 9.03 g, p = 0.001) and SCF groups (27.34 ± 7.93 g, p = 0.037). At 6 months, the change in TBBMD in the SCF + Ca (0.019 ± 0.003 g/cm2) and Ca (0.014 ± 0.003 g/cm2) groups was significantly different (p
METHODS: We report a case of a 49-year-old lady with history of poliomyelitis with resultant flaccid paralysis of the involved limb.
RESULTS: The bone mineral density revealed asymmetrical severe osteoporosis in the poliomyelitic limb. Given the risk of falls and fractures, she was commenced on oral bisphosphonate therapy.
CONCLUSION: Poliomyelitis is an important acquired risk factor for regional osteoporosis. This condition should be detected and treated in this cohort of patients who are clearly at higher risk of fractures.
METHODS: On the basis of a series of bone milling experiments with commercial artificial bones, an artificial neural network force model is developed to estimate the milling force of different bone densities as a function of the milling feed rate and spindle speed. The model estimations are used to identify the bone density at the cutting zone by comparing the actual milling force with the estimated one.
RESULTS: The verification experiments indicate the ability of the proposed method to distinguish between one cortical and two cancellous bone densities.
CONCLUSIONS: The significance of the proposed method is that it can be used to discriminate a set of different bone density layers for a range of the milling feed rate and spindle speed.
OBJECTIVE: This study aimed to compare the difference in cytokine profile between postmenopausal women with and without osteoporosis in Klang Valley, Malaysia.
METHODS: Postmenopausal women with (n = 20) and without osteoporosis (n = 20) were recruited for this study. Their bone health status was determined using dual-energy X-ray absorptiometry. Their fasting blood was collected for proteomic analysis. A protein array was performed for four subjects randomly selected from each group to screen the potential cytokines. Three cytokines at least 20% different between groups and consistently expressed by each subject were selected for validation using enzyme-linked immunosorbent assays (ELISA).
RESULTS: The protein array screening demonstrated that platelet-derived growth factor-BB, interleukin- 6 receptor (IL-6R), and tissue inhibitor of metallopeptidase-2 were higher in women with osteoporosis than women without osteoporosis (n = 4 per group), and consistently expressed by all women. Only body mass index (BMI)-adjusted logarithmically transformed IL-6R levels were lower among postmenopausal women with osteoporosis compared to women with normal bone health (p = 0.026) (n = 16 per group) in the ELISA test.
CONCLUSION: IL-6R was lower among postmenopausal women with osteoporosis compared to women with normal bone health after adjusting for BMI. However, a large-scale epidemiological study with proteomic analysis needs to confirm the findings.