This study was conducted to investigate the influence of formulation development methods on the stability (secondary structure, aggregation, and biological activity) of protein drugs embedded in lipid matrices. Catalase, horseradish peroxidase, and α-chymotrypsin were employed as model proteins, while Precirol® AT05 (glyceryl palmitostearate) was used as lipid matrix. Protein-loaded lipid matrices were prepared using melting and mixing and wet granulation methods. Attenuated total reflectance Fourier transform infrared (ATR FT-IR) spectroscopy, size exclusion chromatography (SEC) and biological activity analyses were performed. ATR FT-IR analysis indicated significant interference of the lipid with the protein amide-I band, which was eliminated using spectral subtraction. Wet granulation method induced more changes in protein secondary structure compared to melting and mixing method. SEC analysis gave evidence of protein aggregation for catalase upon adopting the wet granulation method. The biological activity of catalase was found to reduce significantly than other two proteins upon using wet granulation method, which might be ascribed to both secondary structure alterations and the formation of aggregates. Horseradish peroxidase and α-chymotrypsin did not form any soluble aggregates. In conclusion, melting and mixing method emerged as a better incorporation method compared to wet granulation because of better stability shown by the formulated proteins.
Protein drugs are important therapeutic agents however; they may degrade during formulation processing. The objective of this study was to investigate the correlation between secondary structure alterations and the retentions of biological activity of protein upon the application of thermal stress. Catalase, horseradish peroxidase and α- chymotrypsin were employed as model proteins. Each protein was heated in a solid and solution state at a temperature of 70 °C for 1 h. Attenuated total reflectance Fourier transform infrared spectroscopy, size-exclusion chromatography and biological activity assay were performed. Results showed that heat-exposure of protein solids at 70 °C caused minimum changes in secondary structure and biological activity was almost retained. However, thermal exposure of protein aqueous solution induced significant changes in the secondary structure indicated by area overlap values and caused considerable reduction in the biological activity. The changes in secondary structures were found to be in full alignment with the loss of biological activity for both protein solids as well as aqueous solutions. Catalase lost entire biological activity upon heating in the solution state. In conclusion, the findings of the present study indicate a direct correlation between protein secondary structure alterations and the retention of biological activity which can be taken into account during the development and delivery of protein drugs formulations.
Protein drugs may encounter conformational perturbations during the formulation processing of lipid-based solid dosage forms. In aqueous protein solutions, attenuated total reflection Fourier transform infrared (ATR FT-IR) spectroscopy can investigate these conformational changes following the subtraction of spectral interference of solvent with protein amide I bands. However, in solid dosage forms, the possible spectral contribution of lipid carriers to protein amide I band may be an obstacle to determine conformational alterations. The objective of this study was to develop an ATR FT-IR spectroscopic method for the analysis of protein secondary structure embedded in solid lipid matrices. Bovine serum albumin (BSA) was chosen as a model protein, while Precirol AT05 (glycerol palmitostearate, melting point 58 ℃) was employed as the model lipid matrix. Bovine serum albumin was incorporated into lipid using physical mixing, melting and mixing, or wet granulation mixing methods. Attenuated total reflection FT-IR spectroscopy and size exclusion chromatography (SEC) were performed for the analysis of BSA secondary structure and its dissolution in aqueous media, respectively. The results showed significant interference of Precirol ATO5 with BSA amide I band which was subtracted up to 90% w/w lipid content to analyze BSA secondary structure. In addition, ATR FT-IR spectroscopy also detected thermally denatured BSA solid alone and in the presence of lipid matrix indicating its suitability for the detection of denatured protein solids in lipid matrices. Despite being in the solid state, conformational changes occurred to BSA upon incorporation into solid lipid matrices. However, the extent of these conformational alterations was found to be dependent on the mixing method employed as indicated by area overlap calculations. For instance, the melting and mixing method imparted negligible effect on BSA secondary structure, whereas the wet granulation mixing method promoted more changes. Size exclusion chromatography analysis depicted the complete dissolution of BSA in the aqueous media employed in the wet granulation method. In conclusion, an ATR FT-IR spectroscopic method was successfully developed to investigate BSA secondary structure in solid lipid matrices following the subtraction of lipid spectral interference. The ATR FT-IR spectroscopy could further be applied to investigate the secondary structure perturbations of therapeutic proteins during their formulation development.
Protein biologics are prone to conformational changes during formulation development. Limited methods are available for conformational analysis of proteins in solid state and in the presences of formulation excipients. The aim of this study was to investigate the secondary structures of proteins encased in solid lipid matrices as a novel indicator of their stability upon in vitro release. Model proteins namely catalase and lysozyme were incorporated into lipid namely Precirol® AT05 (glycerol palmitostearate, melting point 58°C) at 30% w/w loading using melting and mixing and wet granulation methods. Attenuated total reflectance (ATR-FTIR) spectroscopy, size-exclusion chromatography (SEC) and biological activity analyses were performed. The information about secondary structure was acquired using second derivative analysis of amide-I band (1600-1700 cm-1). ATR analysis demonstrated interference of lipid spectrum with protein amide-I band which was subsequently subtracted to allow the analysis of the secondary structure. ATR spectra amide-I bands showed shifts peak band positions compared to native protein for matrices prepared using wet granulation. SEC analysis gave evidence of protein aggregation for catalase which was increased using wet granulation. The biological activity of catalase was statistically different from that of control and was affected by the incorporation method and was found to be in alignment with ATR spectral changes and extent of aggregation. In conclusion, ATR spectroscopy could analyze protein secondary structure in lipid matrices provided lipid interference was minimized. The ATR spectral changes and formation of aggregates can indicate the loss in biological activity of protein released from solid lipid matrices.