Displaying all 2 publications

Abstract:
Sort:
  1. Pathogenicity and immunogenicity of mynah pox virus in chickens and bobwhite quail
    Reed WM, Schrader DL
    Poult Sci, 1989 May;68(5):631-8.
    PMID: 2547209
    An avian pox virus was isolated from cutaneous proliferative lesions removed from greater hill mynahs (Gracula religiosa) imported from Malaysia. Cutaneous inoculation of specific pathogen-free chickens and bobwhite quail with the mynah pox virus resulted in severe proliferative cutaneous lesions similar to those seen in the naturally infected mynah birds. Microscopically, the reaction in the chickens and quail at sites of virus inoculation was characterized by marked epithelial hyperplasia with ballooning degeneration and formation of cytoplasmic inclusion bodies. Inoculation of conjunctival and oral mucosae of chickens by applying pox virus with a cotton swab did not result in gross or microscopic lesions. In cross-protection studies, chickens and bobwhite quail immunized with either quail, fowl, pigeon, turkey, or psittacine pox vaccines were not protected from challenge with mynah pox virus. Following vaccination of quail and chickens with mynah pox virus vaccine, there was no resistance to challenge by quail, fowl, pigeon, turkey, or psittacine pox viruses. Significant protection against development of lesions following inoculation with mynah pox virus was attained only when the homologous virus was used as a vaccine.
  2. Fulltext Increasing iterative reconstruction strength at low tube voltage in coronary CT angiography protocols using 3D-printed and Catphan® 500 phantoms
    Abdullah KA, McEntee MF, Reed WM, Kench PL
    J Appl Clin Med Phys, 2020 Sep;21(9):209-214.
    PMID: 32657493 DOI: 10.1002/acm2.12977
    PURPOSE: The purpose of this study was to investigate the effect of increasing iterative reconstruction (IR) algorithm strength at different tube voltages in coronary computed tomography angiography (CCTA) protocols using a three-dimensional (3D)-printed and Catphan® 500 phantoms.

    METHODS: A 3D-printed cardiac insert and Catphan 500 phantoms were scanned using CCTA protocols at 120 and 100 kVp tube voltages. All CT acquisitions were reconstructed using filtered back projection (FBP) and Adaptive Statistical Iterative Reconstruction (ASIR) algorithm at 40% and 60% strengths. Image quality characteristics such as image noise, signal-noise ratio (SNR), contrast-noise ratio (CNR), high spatial resolution, and low contrast resolution were analyzed.

    RESULTS: There was no significant difference (P > 0.05) between 120 and 100 kVp measures for image noise for FBP vs ASIR 60% (16.6 ± 3.8 vs 16.7 ± 4.8), SNR of ASIR 40% vs ASIR 60% (27.3 ± 5.4 vs 26.4 ± 4.8), and CNR of FBP vs ASIR 40% (31.3 ± 3.9 vs 30.1 ± 4.3), respectively. Based on the Modulation Transfer Function (MTF) analysis, there was a minimal change of image quality for each tube voltage but increases when higher strengths of ASIR were used. The best measure of low contrast detectability was observed at ASIR 60% at 120 kVp.

    CONCLUSIONS: Changing the IR strength has yielded different image quality noise characteristics. In this study, the use of 100 kVp and ASIR 60% yielded comparable image quality noise characteristics to the standard CCTA protocols using 120 kVp of ASIR 40%. A combination of 3D-printed and Catphan® 500 phantoms could be used to perform CT dose optimization protocols.

Related Terms
    Try searching for something
Filters
Contact Us

Please provide feedback to Administrator ([email protected])

External Links