Biodiesel is considered as a key prospective renewable energy source in India. Hence, a study was carried out for the improvement of palm kernel oil biodiesel production using a transesterification process at different molar ratios. This study comprehensively examined all aspects of biodiesel from optimum production to the effect of additives on its combustion behavior. The optimum yield condition was validated with the MINITAB-17 software and analyzed using the Taguchi method. Two different additives, 5% diethyl ether (DEE) and 2000 ppm Butylated hydroxyltoluene (BHT), were also experimented. Engine experiments were conducted at constant speed (1500 rpm) and five different engine loads (0, 25, 50, 75 and 100%) on a single-cylinder direct injection diesel engine. Heat release rate, brake specific fuel consumption, brake thermal efficiency, engine emissions, such as CO, HC, NOx, and smoke opacity were analyzed. The maximum palm kernel oil (PKO) biodiesel yields, obtained at 55 °C, for the KOH and NaOH catalysts were 86.69% and 75.21% at the molar ratio of 6:1. B20BHT combustion showed 4.6% higher brake thermal efficiency (BTE). NOx emission was reduced by 19.4%, compared to the diesel fuel values. DEE resulted in higher CO and HC emissions compared to diesel fuel values by 39.2% and 7.6%, respectively, whereas smoke emission was improved by 11.5%.
Integrated environmental analysis using life cycle assessment for different fuel blends used in a single-cylinder diesel engine was performed to select the most eco-friendly fuel blend. More specifically, the inventory data in support of the integrated environmental analysis of water-emulsified 5% biodiesel/diesel blends (B5) containing different levels of carbon nanoparticles (i.e., 38, 75, and 150 µM) as a novel fuel nanoadditives at a fixed engine speed of 1000 rpm and four different engine loads (i.e., 25, 50, 75, and 100%) are presented. Neat diesel, B5, and B5 containing water (3 wt.%) were used as controls. Raw data related to the production and combustion of fuel blends were experimentally collected. Industrial (i.e., experiments at large scale) and laboratory (i.e., experiments at small scale) data were used for fuel blends production while experimental data obtained by engine tests were used for the combustion stage. Then raw data were processed with the IMPACT 2002+ methods by using the SimaPro software and EcoInvent database and were then converted into environmental impacts. Accordingly, six supplementary files including the inventory data on integrated environmental analysis of the different fuel blends are presented (Supplementary Files 1-6). The data could be applied for integrated environmental analysis in order to avoid subjective weighting of combustion parameters for selecting the most eco-friendly fuel blend for use in diesel engines. More specifically, by developing a single score indicator obtained through conducting integrated combustion analysis, comparison of various fuel blends is largely facilitated.