Patches has recently emerged and attracting more attention for its versatility in many areas such as cosmetic, pharmaceutical and medical. Patches can either be used to administer selected drug to skin or deliver some beneficial ingredients for cosmetic purposes. With that, as polymer is used as the matrix for patches, the polymer selected must be non-toxic, have adhesive property and non-irritative to the skin. Currently, synthetic polymer had been used as the matrix. However, as time passes, people are more concern with the environment, therefore biopolymer is chosen over synthetic polymer as they are degradable and also safe to use. Nowadays, as consumers are demanding for a more effective product that is not only good for appearance but also the health of the skin, studies had been done on many kinds of active ingredient that will give the best effect to the skin. Thus in this paper, patches made up of different combinations of polymer and active ingredients, as well as fabrication method currently used to produce patches will be discussed.
The concern about our dependency on non-renewable resources and overwhelming environmental issues such as pollution caused by non-degradable packaging materials has prompted researchers to come up with alternatives to solve this problem. Thermoplastic polylactic acid (PLA) has been gaining interest due to its versatility and easy processability, thus this study was carried out to find out the properties of PLA reinforced with pineapple fibers. However, surface of the natural fibers need to be treated for better properties enhancement in the polymer matrices. Considering this, fibers were treated with 10% (w/v) concentration of potassium hydroxide (KOH) and then continued for mixing with PLA at a fixed ratio of plasticizer by using internal mixer, and then the composites were prepared into sheet via hot press. Characterization for the mechanical and morphological was conducted by using tensile testing and scanning electron microscopy, respectively. After the analysis, it is found that the surface treated pineapple fiber composite showed better elongation at break compared to untreated fiber composite. The enhance properties of PLA nanocomposites has potential to be used in various packaging materials.
Carbon capture and storage (CCS) involves capturing, transporting and storing CO2 geologically underground permanently. Carbon capture using solvent such as amine and aqueous ammonia has been extensively studied by many researchers. However, this capture technology for CCS scheme is costly. As an alternative, CO2 emission can be cost-effectively captured and stored by utilizing the well-understood natural photosynthetic process of marine cyanobacteria. In contrast, the capturing process using cyanobacteria is very slow compared to the chemical absorption mentioned prior. Hence, this study aimed to investigate carbon capturing and storing process using integrated aqueous ammonia and mutated marine cyanobacteria (Synechococcus PCC 7002 IIUM01). The conditions that can maximize CO2 reduction under various conditions; CO2 flow rate (Lpm), absorption temperature (C) and aqueous ammonia concentrations (% (w/v)) were to be identified. The effectiveness of the mutant cyanobacteria was quantified by measuring the cell concentration, percentage reduction in CO2 concentration and lipid content. Synechococcus PCC 7002 IIUM01 showed it robustness by growing in aqueous ammonia solution at the concentration of 0.5 to 1% (w/v) at which the parent strain was not able to tolerate. The best conditions in maximizing CO2 capture and storage while sustaining growth optimally and being a potential biofuel source was observed at 0.5 Lpm of 15% CO2 gas flow rate, 0.75% (w/v) of ammonia concentration and 33C of absorption temperature. At this specified condition, around 68% of CO2 removal was achieved with 9% (w/w) yield of lipid and more than 13% (w/v) of cell concentration obtained.