Liberica coffee is the most important coffee species grown in Malaysia. However, there is little or no research at all conducted on coffee berries and green coffee beans since the plant itself is a low income crop in Malaysia. Therefore, research on Malaysian Liberica coffee can help to increase the knowledge of coffee farmers and coffee manufacturers in the processing and handling of the coffee. Physical properties of Liberica coffee berries and beans were investigated the current study. The properties investigated include the size, mass, density, coefficient of friction, angle of repose, fracture force and colour. In comparison to Arabica and Robusta coffee, Liberica coffee has the biggest size, mass, true density and fracture force values but were lower in bulk density in both berries and beans. The Liberica berries and beans were found to be orange-ish and yellowish colour respectively. Angle of repose was low and approximately similar in berries and beans while jute fibre gave the highest friction to both Liberica berries and beans.
Two patients with ascending aortic aneurysms due to cystic medical necrosis are described. One of them was phenotypically normal while the other had features of Marfan's syndrome. Both were disabled by dyspnoea and angina which required corrective surgery.
A patient with a left atrial myxoma is reported to illustrate the value of two dimensional real time echocardiography in the diagnosis of intracavitary cardiac tumours.
The complications of temporary transvenous endocardial pacing as performed in the University Hospital Kuala Lumpur, from 1971 to 1979 were reviewed. 125 temporary pacings were performed in 111 patients. Different routes of temporary pacing
were used: namely percutaneous subclavian vein and femoral vein puncture and acutecubital vein cutdown. The latter route was associated with a higher incidence of dislodgement and infection. Other common complications encountered were ventricular arrhythymia and generator failure.
Acute nonspecific carditis with advanced heart block is rare. We observed nine cases with complete heart block and one with Mobitz type II block over an eight and a half year period. Temporary cardiac pacing was instituted in all while permanent pacing was required in six patients. No death was recorded.
The predilection of a bi-layered tablet to fail in the interface region after its initial formation in the compaction process reduces its practicality as a choice for controlled release solid drug delivery system. Hence, a fundamental appreciation of the governing mechanism that causes the weakening of the interfacial bonds within the bi-layered tablet is crucial in order to improve the overall bi-layered tablet mechanical integrity. This work has shown that the occurrence of the elastic relaxation in the interface region during the ejection stage of the compaction process decreases with the increase in the bi-layered tablet interface strength. This is believed to be due to the increase in the plastic bonding in the interface region. The tablet diametrical elastic relaxation affects the tablet height elastic relaxation, where the impediment of the tablet height expansion is observed when the interface region experiences a diametrical expansion.
It is generally accepted that the tablet elastic relaxation during compaction plays a vital role in undermining the final tablet mechanical integrity. One of the least investigated stages of the compaction process is the ejection stage.
A newly discovered, diminutive, cave-dwelling, lowland species of the colubrid snake genus Lycodon Boie is described from a limestone cave along the Thai-Malaysian border in the state of Perlis, northwestern Peninsular Malaysia. Lycodon cavernicolus sp. nov. is most closely related to L. butleri Boulenger, an endemic, upland, forest-dwelling species from Peninsular Malaysia of the fasciatus group but is separated from L. butleri and all other species of the L. fasciatus group and the closely related L. ruhstrati group by having the combination of 245 (male) and 232 (female) ventral scales; 113 (male) and 92 (female) paired, subcaudal scales; a single precloacal plate; nine or 10 supralabials; 10 or 11 infralabials; a maximum total length of 508 mm (female); a relative tail length of 0.25-0.27; an immaculate venter in juveniles and dark-brown, posterior, ventral scale margins in adults; and dorsal and caudal bands in juveniles white. The discovery of L. cavernicolus sp. nov. adds to a rapidly growing list of newly discovered reptiles from karst regions and limestone forests of Peninsular Malaysia, underscoring the fact that these areas should be studied before they are quarried as they harbor a significant portion of the Peninsular Malaysia's herpetological diversity.
The optimum combination of Baccaurea angulata fruit juice (X1: 15 - 85 ratio) and Trigona sp. honey (TH) (X2: 15 - 85 ratio) in developing a high antioxidant soft jelly was investigated based
on the antioxidant capacity (Y1), phenolic (Y2), and flavonoid (Y3) content. Response surface
methodology (RSM), via central composite design (CCD), was used to produce optimal combination effects of the two independent variables (B. angulata fruit juice and TH) for highest
recovery of antioxidant capacity (AC), total phenolic content (TPC), and total flavonoid content
(TFC). The polynomial models generated were satisfactory. The lack-of-fit test were higher
than p > 0.05 for all three analyses, signifying the suitability of the models in accurately predicting the variations. Predicted values of the analysis agreed with those of the experimental values.
An optimum combination of B. angulata fruit juice and TH was developed (ratio 40:40). The
sample also exhibited significant FRAP and DPPH radical scavenging activities. Several
polyphenols were identified for the samples through UHPLC-MS/MS. In conclusion, B. angulata and Trigona sp. honey have high potentials to be used in fortifying the soft jelly samples,
making them prospective food supplements due to their nutritional and health benefits.
This study aimed to evaluate the benefits of using sawdust, pinewood shavings, and rubber wood shavings as horse bedding materials. Nine horses were used in a repeated measure design, where each horse was provided with each of the bedding materials for two consecutive weeks. The weight, cost, mucking out time, ammonia emissions, and urine holding capacity were measured and calculated for each bedding material. Results showed that pinewood shavings had the highest urine-holding capacity, while rubber wood shavings had the lowest absorbency for urine. Pinewood shavings also had lower ammonia emissions compared to sawdust and rubber wood shavings but were significantly more expensive. Sawdust was the cheapest of the three bedding materials, but it was used in greater quantities, which required more time for mucking out. The findings from this study could be used to make informed decisions on bedding materials for stables, taking into consideration the trade-off between cost, maintenance requirements, and labor hours.
A new species of lowland karst dwelling Cnemaspis Strauch 1887, C. grismeri sp. nov. is described from the southeastern base of the Banjaran Bintang in northern Peninsular Malaysia. It is differentiated from its congeners by a unique combination of characters including size, coloration and scalation. Cnemapis grismeri sp. nov. is most closely related to C. mcguirei, an upland species endemic to the Banjaran Bintang. This phylogeographic pattern is also seen in the upland and lowland Banjaran Bintang species of Cyrtodactylus bintangtinggi and C. bintangrendah, respectively (Grismer et al. 2012). The discovery of yet another endemic gekkonid in the poorly explored karst regions of Peninsular Malaysia underscores the necessity for concentrated collecting efforts in these unique landscapes.
The process of manual species identification is a daunting task, so much so that the number of taxonomists is seen to be declining. In order to assist taxonomists, many methods and algorithms have been proposed to develop semi-automated and fully automated systems for species identification. While semi-automated tools would require manual intervention by a domain expert, fully automated tools are assumed to be not as reliable as manual or semiautomated identification tools. Hence, in this study we investigate the accuracy of fully automated and semi-automated models for species identification. We have built fully automated and semi-automated species classification models using the monogenean species image dataset. With respect to monogeneans' morphology, they are differentiated based on the morphological characteristics of haptoral bars, anchors, marginal hooks and reproductive organs (male and female copulatory organs). Landmarks (in the semi-automated model) and shape morphometric features (in the fully automated model) were extracted from four monogenean species images, which were then classified using k-nearest neighbour and artificial neural network. In semi-automated models, a classification accuracy of 96.67 % was obtained using the k-nearest neighbour and 97.5 % using the artificial neural network, whereas in fully automated models, a classification accuracy of 90 % was obtained using the k-nearest neighbour and 98.8 % using the artificial neural network. As for the crossvalidation, semi-automated models performed at 91.2 %, whereas fully automated models performed slightly higher at 93.75 %.
Species in the genus Pseudocalotes are generally rare and known only from a few specimens. Pseudocalotes drogon was described based on a single male from Frasers Hill, Pahang, Peninsular Malaysia. During a recent field survey at Frasers Hill, a female specimen was collected and identified as P. drogon based on morphological characters and a molecular phylogenetic analysis. The morphological description of P. drogon is expanded here, based on the male holotype and the newly collected female specimen.
An extractive fermentation technique was developed using a thermoseparating reagent to form a two-phase system for simultaneous cell cultivation and downstream processing of extracellular Burkholderia cepacia lipase. A 10% (w/w) solution of ethylene oxide-propylene oxide (EOPO) with a molecular mass of 3900 g/mol and pH 8.5, a 200 rpm speed, and 30 °C were selected as the optimal conditions for lipase production (55 U/ml). Repetitive batch fermentation was performed by continuous replacement of the top phase every 24h, which resulted in an average cell growth mass of 4.7 g/L for 10 extractive batches over 240 h. In scaling-up the process, a bench-scale bioreactor was tested under the conditions that had been optimized in flasks. The production rate and recovery yield were higher in the bioreactor compared to fermentation performed in flasks.